Electrical Junction Box, Wall or Ceiling
Bolt-On
View:
Active Filters :
$
46.59
Qty:
Part #:BRKSMICO105-AC
$
57.92
Qty:
Part #:SMI100-AC
- 120V AC/DC Smoke Alarm The 9120 Series smoke alarms have been designed to install faster, perform better and be even smarter than before. These improvements help reduce nuisance alarms and save you time and money.
» Single button test/silence » 9V Battery Backup » Latching alarm indicator - remembers which unit initiated an alarm » Smart Technology - helps reduce the number of nuisance alarms » Perfect Mount - allows for easy alignment of alarm » Dust Cover » Easy Installation/Maintenance - Preferred features include a large opening in the mounting bracket for easy access to wiring. Keyhole slots in the mounting bracket eliminate the need to remove the electrical box screws for installation. A battery pull tab keeps the battery fresh until the home is occupied. Battery installation and removal can occur while the unit is mounted to the ceiling or wall via the side load battery compartment. Two locking features are provided to prevent battery theft and/or theft of the unit. Connection to AC power is made with a "Quick-Connect" wiring harness. Installation is quick, easy and cost effective. » 10-Year Limited Warranty
$
14.91
Qty:
Part #:SMICO100-AC
- 120V AC/DC Smoke/CO Combo Alarm Hardwired ionization/CO combination alarm meets new construction requirements.
» 10YR CO Sensor/10YR End of Life » Electrochemical Carbon Monoxide Sensor - the most accurate sensor available as compared to other sensing technologies » 9V Alkaline Battery Backup » Latching alarm indicator - remembers which unit initiated an alarm » Two silence features - can silence the low-battery chirp for up to eight hours or temporarily silence an unwanted nuisance alarm » End of Life Signal provides audible notification alarms needs to be replaced » Intelligent Sensing TechnologyTM helps reduce the number of nuisance alarms » Perfect Mount - allows for easy alignment of alarm » Dust Cover » Easy Installation/Maintenance - Preferred features include a large opening in the mounting bracket for easy access to wiring. Keyhole slots in the mounting bracket eliminate the need to remove the electrical box screws for installation. A battery pull tab keeps the battery fresh until the home is occupied. Battery installation and removal can occur while the unit is mounted to the ceiling or wall via the side load battery compartment. Two locking features are provided to prevent battery theft and/or theft of the unit. Connection to AC power is made with a "Quick-Connect" wiring harness. Installation is quick, easy and cost effective. » Single button test/silence » 10-Year Limited Warranty
$
61.28
Qty:
Part #:KIDI4618A
- The Kidde i4618 is an AC/DC powered, ionization smoke alarm that operates on a 120V power source with 9V battery backup. This alarm uses ionization sensing technology. Ionization sensing alarms may detect invisible fire particles (associated with flaming fires) sooner than photoelectric alarms. Photoelectric sensing alarms may detect visible particles (associated with smoldering fires) sooner than ionization alarms.
The front-loading battery door allows user to change the battery without removing the alarm from the mounting bracket making battery replacement easy and convenient. This smoke alarm is available in a 6-piece cut case with tray for easy display as well as a 6-piece bulk pack for contractors and property owners. This unit is a UL Listed product with a 5-year limited warranty. Kidde strongly recommends that both ionization and photoelectric smoke alarms be installed to help insure maximum detection of the various types of fire that can occur within the home.
Easy Installation
&bull Front battery pull tab allows battery activation without removing alarm from mounting bracket.
&bull Large mounting base makes mounting easier, protects surface paint from dirt and covers imperfections.
&bull Pre-stripped wiring harness with easy off cap does not require stripper tool. Tinned strands increase conductivity and wire nut grip.
Fewer Callbacks
&bull Large centrally located Test/Hush® alarm control button.
&bull Dust cover protects sensor from contaminates during construction reducing nuisance alarms.
User-Friendly Features
&bull Easy access front loading battery door.
&bull Battery backup provides protection in case of power failure.
&bull Interconnectable with up to 24 devices (of which 18 can be initiating) including smoke, CO and heat alarms. See user&rsquos guide for complete instructions.
Technical Specifications
Model
i4618
UPC
0-47871-07581-2
Power Source
120VAC (80mA Max)
Sensor
Ionization
Audio Alarm
85dB at 10ft
Temperature Range
40°F (4.4°C) to 100°F (37.8°C)
Humidity Range
Up to 85% relative humidity (RH)
Size
5.6 in diameter x 1.8 in depth
Weight
.5lbs
Interconnects
Up to 24 Kidde devices
LED
Green, receiving ac power,Red, 4 modes of operation
Warranty
5 year limited
$
12.77
Qty:
Part #:I12040
- SMOKE ALARM WITH STROBE LIGHT TYPE AC/DC IONIZATION OPERATION TYPE UL APPROVAL 85 DB AT 10 FT HORN TYPE 120 VAC 60 HZ WITH 9 V BATTERY BACKUP VOLTAGE RATING/SOURCE LED INDICATING CONDITION LED/STROBE TYPE 24 INTERCONNECTION(S) SIZE 6.5 INCH W X 13.25 INCH D X 6 INCH H
$
23.04
Qty:
$
182.94
Qty:
Part #:MIDWUG412RMW260
- GFI TYPE 6 TO 2/0 AWG LUG WIRE SIZE G90 GALVANIZED STEEL ENCLOSURE MATERIAL UL, CUL APPROVAL 120/240 V VOLTAGE RATING NEMA 3R ENCLOSURE 10 KILOAMPERE INTERRUPTING RATING 125 AMPERE CURRENT RATING 2 POLE(S) GRAY ENCLOSURE FINISH
$
192.86
Qty:
Part #:MIDWB12
- BOLT-ON MOUNTING 10 STANDARD PACKAGE 1-1/4 INCH CONDUIT SIZE
$
11.14
Qty:
Part #:MIDWB20
- BOLT-ON MOUNTING 10 STANDARD PACKAGE 2 INCH CONDUIT SIZE
$
12.48
Qty:
Part #:MIDWU075CTL010
- UNMETERED TYPE G90 STEEL MATERIAL ZINC COATED FINISH 14 TO 8 AWG SOLID, 14 TO 1/0 AWG STRANDED (COPPER, LINE), 12 TO 8 AWG SOLID, 12 TO 1/0 AWG STRANDED (ALUMINUM, LINE), 14 TO 8 AWG SOLID, 14 TO 1/0 AWG STRANDED (COPPER, LOAD), 12 TO 8 AWG SOLID, 12 TO 1/0 AWG STRANDED (COPPER, NEUTRAL-LARGE HOLE), 10 TO 8 WIRE SIZE UL, CUL APPROVAL NEMA 3R ENCLOSURE 100 AMP CURRENT RATING 1-PHASE CIRCUIT CONFIGURATION NO ILLUMINATED CB250 FIRST POSITION CIRCUIT BREAKER TYPE BR54U LEFT POSITION RECEPTACLE TYPE CB120 THIRD POSITION CIRCUIT BREAKER TYPE CB130 SECOND POSITION CIRCUIT BREAKER TYPE 5-20R2GFCI RIGHT POSITION RECEPTACLE TYPE R32U CENTER POSITION RECEPTACLE TYPE VOLTAGE RATING 120/240 VOLT CABINET DIMENSION 9-3/4 INCH WIDTH X 5-3/16 INCH DEPTH X 17-3/8 INCH HEIGHT MOUNTING TYPE SURFACE APPLICABLE STANDARD NEMA, NEC
$
279.32
Qty:
Part #:NBHBK125LWH
- WIRED CHIME TYPE 9 INCH WIDTH X 2 INCH DEPTH X 5 INCH HEIGHT SIZE WHITE COLOR (2) LIGHTED PUSHBUTTON CONTENTS 16 VOLT OPERATING VOLTAGE TRANSFORMER POWER SUPPLY TYPE 2 ENTRANCE(S) BK MODEL
$
23.48
Qty:
Displaying: 1 - 12 of 12 Matching Items