Ul 870, Csa c22.2, Iec 60529
Ul 514b, Csa c22.2, Federal Specification W-C-586d
View:
Active Filters :
$
112.50
Qty:
$
60.00
Qty:
$
60.00
Qty:
$
57.92
Qty:
Part #:BRKSC9120B
- 120V AC/DC Smoke/CO Combo Alarm Hardwired ionization/CO combination alarm meets new construction requirements.
» 10YR CO Sensor/10YR End of Life » Electrochemical Carbon Monoxide Sensor - the most accurate sensor available as compared to other sensing technologies » 9V Alkaline Battery Backup » Latching alarm indicator - remembers which unit initiated an alarm » Two silence features - can silence the low-battery chirp for up to eight hours or temporarily silence an unwanted nuisance alarm » End of Life Signal provides audible notification alarms needs to be replaced » Intelligent Sensing TechnologyTM helps reduce the number of nuisance alarms » Perfect Mount - allows for easy alignment of alarm » Dust Cover » Easy Installation/Maintenance - Preferred features include a large opening in the mounting bracket for easy access to wiring. Keyhole slots in the mounting bracket eliminate the need to remove the electrical box screws for installation. A battery pull tab keeps the battery fresh until the home is occupied. Battery installation and removal can occur while the unit is mounted to the ceiling or wall via the side load battery compartment. Two locking features are provided to prevent battery theft and/or theft of the unit. Connection to AC power is made with a "Quick-Connect" wiring harness. Installation is quick, easy and cost effective. » Single button test/silence » 10-Year Limited Warranty
$
44.25
Qty:
Part #:BLIN4436GGV-NK
- LAY-IN TYPE 16 GAUGE STEEL MATERIAL GALVANIZED FINISH 36 INCH 4 INCH 4 INCH UL 870, CSA C22.2 APPROVAL NEMA 1, IP20 ENCLOSURE SCREW COVER TYPE NO KNOCKOUT(S) APPLICABLE STANDARD IEC 529 APPLICATION HOUSES RUNS OF CONTROL AND POWER CABLE, USED FOR CABLE AND WIRE JUNCTION, DISTRIBUTION AND TERMINATION
$
20.81
Qty:
Part #:BLIN6660GGV-NK
- LAY-IN TYPE 16 GAUGE STEEL MATERIAL GALVANIZED FINISH 60 INCH 6 INCH 6 INCH UL 870, CSA C22.2 APPROVAL NEMA 1, IP20 ENCLOSURE SCREW COVER TYPE NO KNOCKOUT(S) APPLICABLE STANDARD IEC 529 APPLICATION HOUSES RUNS OF CONTROL AND POWER CABLE, USED FOR CABLE AND WIRE JUNCTION, DISTRIBUTION AND TERMINATION
$
44.32
Qty:
Part #:BLIN8860GGV-NK
- LAY-IN TYPE 14 GAUGE STEEL MATERIAL GALVANIZED FINISH 60 INCH 8 INCH 8 INCH UL 870, CSA C22.2 APPROVAL NEMA 1, IP20 ENCLOSURE SCREW COVER TYPE NO KNOCKOUT(S) APPLICABLE STANDARD IEC 529 APPLICATION HOUSES RUNS OF CONTROL AND POWER CABLE, USED FOR CABLE AND WIRE JUNCTION, DISTRIBUTION AND TERMINATION
$
88.69
Qty:
Part #:BLIN4460GNK
- LAY-IN TYPE 16 GAUGE STEEL MATERIAL ANSI 61 GRAY ACRYLIC ELECTROCOATED OVER PHOSPHATIZED SURFACE FINISH 60 INCH 4 INCH 4 INCH UL 870, CSA C22.2 APPROVAL NEMA 1, IP20 ENCLOSURE SCREW COVER TYPE NO KNOCKOUT(S) APPLICABLE STANDARD IEC 529 APPLICATION HOUSES RUNS OF CONTROL AND POWER CABLE, USED FOR CABLE AND WIRE JUNCTION, DISTRIBUTION AND TERMINATION
$
33.28
Qty:
Part #:BLIN4448GRT-NK
- 16 GAUGE STEEL MATERIAL ANSI 61 GRAY ACRYLIC ELECTROCOATED OVER PHOSPHATIZED SURFACE FINISH 48 INCH 4 INCH 4 INCH UL 870, CSA C22.2, IEC 529 APPROVAL NEMA 3R, IP24 ENCLOSURE SCREW COVER TYPE WIRING TROUGH NO KNOCKOUT(S) APPLICATION POWER CABLE AND WIRE JUNCTION, DISTRIBUTION AND TERMINATION
$
71.03
Qty:
Part #:CRS670
- BLANK, SCREW, WEDGENUT TYPE SHEET STEEL (COVER), STAINLESS STEEL (SCREW) MATERIAL 7 INCH UL 514B, CSA C22.2 APPROVAL 2 INCH TRADE SIZE FORM 7 FORM TYPE COOPER CROUSE-HINDS BRAND APPLICATION NON-HAZARDOUS LOCATION
$
23.41
Qty:
Part #:CRSLL67
- ELECTROGALVANIZED ALUMINUM ACRYLIC PAINTED FERALOY IRON ALLOY (BODY), STAINLESS STEEL (SCREW) MATERIAL 8.125 INCH LENGTH X 3.125 INCH WIDTH X 4.125 INCH HEIGHT SIZE RIGID CONDUIT USED ON 2 INCH HUB SIZE THREADED INSTALLATION LL CONFIGURATION 2 HUB(S) UL 514B, CSA C22.2 APPROVAL ELECTROGALVANIZED ALUMINUM ACRYLIC PAINTED FERALOY IRON ALLOY, SNAP TIGHT, SCREW COVER TYPE 90 DEGREE HUB LOCATION FORM 7 FORM TYPE LEFT SIDE ACCESS OPENING COOPER CROUSE-HINDS BRAND APPLICATION NON-HAZARDOUS LOCATION APPLICABLE STANDARD FEDERAL SPECIFICATION WC-586D LL MODEL
$
132.71
Qty:
Part #:CRSLR37
- ELECTROGALVANIZED ALUMINUM ACRYLIC PAINTED FERALOY IRON ALLOY (BODY), STAINLESS STEEL (SCREW) MATERIAL 6 INCH LENGTH X 1.875 INCH WIDTH X 2.75 INCH HEIGHT SIZE RIGID CONDUIT USED ON 1 INCH HUB SIZE THREADED INSTALLATION LR CONFIGURATION 2 HUB(S) UL 514B, CSA C22.2 APPROVAL ELECTROGALVANIZED ALUMINUM ACRYLIC PAINTED FERALOY IRON ALLOY, SNAP TIGHT, SCREW COVER TYPE 90 DEGREE HUB LOCATION FORM 7 FORM TYPE RIGHT SIDE ACCESS OPENING COOPER CROUSE-HINDS BRAND APPLICATION NON-HAZARDOUS LOCATION APPLICABLE STANDARD FEDERAL SPECIFICATION WC-586D LR MODEL
$
23.63
Qty:
Part #:CRSLR67
- ELECTROGALVANIZED ALUMINUM ACRYLIC PAINTED FERALOY IRON ALLOY (BODY), STAINLESS STEEL (SCREW) MATERIAL 8.125 INCH LENGTH X 3.125 INCH WIDTH X 4.125 INCH HEIGHT SIZE RIGID CONDUIT USED ON 2 INCH HUB SIZE THREADED INSTALLATION LR CONFIGURATION 2 HUB(S) UL 514B, CSA C22.2 APPROVAL ELECTROGALVANIZED ALUMINUM ACRYLIC PAINTED FERALOY IRON ALLOY, SNAP TIGHT, SCREW COVER TYPE 90 DEGREE HUB LOCATION FORM 7 FORM TYPE RIGHT SIDE ACCESS OPENING COOPER CROUSE-HINDS BRAND APPLICATION NON-HAZARDOUS LOCATION APPLICABLE STANDARD FEDERAL SPECIFICATION WC-586D LR MODEL
$
132.71
Qty:
Part #:CRST27
- ELECTROGALVANIZED ALUMINUM ACRYLIC PAINTED FERALOY IRON ALLOY (BODY), STAINLESS STEEL (SCREW) MATERIAL 6.25 INCH LENGTH X 2 INCH WIDTH X 2.625 INCH HEIGHT SIZE RIGID CONDUIT USED ON 3/4 INCH HUB SIZE THREADED INSTALLATION T CONFIGURATION 3 HUB(S) UL 514B, CSA C22.2 APPROVAL ELECTROGALVANIZED ALUMINUM ACRYLIC PAINTED FERALOY IRON ALLOY, SNAP TIGHT, SCREW COVER TYPE TEE HUB LOCATION FORM 7 FORM TYPE SIDE ACCESS OPENING COOPER CROUSE-HINDS BRAND APPLICATION NON-HAZARDOUS LOCATION APPLICABLE STANDARD FEDERAL SPECIFICATION WC-586D T MODEL
$
32.63
Qty:
Displaying: 1 - 15 of 15 Matching Items